A full own-design, homebrew 2.4Ghz FHSS proportional system:
This is a simple expandable four channel RC outfit based on the NRF24L01+ using true Frequency Hopping.
Its development was documented in real time on the mode-zero forum, and has run to over 270 posts...
Its a very long thread, hence the need for a more concise how-to document!
The system uses a unique protocol which sends one packet every 5ms, each packet containing all the control positions,
so 200 updates per second.
It uses sixteen RF channels well spread through the band, and has full failsafe on all channels, set at the rx or from the tx.
The system works very well, has logged hundreds of hours with dozens of sets in use.
It has many unique features, eg model memory inside each receiver rather than the conventional transmitter based model memories,
saving mixers, servo-reversing, and trim settings etc within each individual receiver, meaning I can fly any of my models
with any of my transmitters without selecting or changing anything - I can switch transmitters in flight!
I've done many variations using the same FHSS core including Single-Channel escapement emulation, Reeds emulation, 1+1, 2+1, GG and more:
Some demo videos of my own design homebrew FHSS system:
My PPM Encoder projects are listed here
These have been hugely popular amongst retro-conversion enthusiasts over the years, with thousands in use.
Proportional, Reeds emulation, Galloping Ghost, single-channel escapement emulation, one-plus-one, 2+1, etc...